Case studies
Bodies, housings and wear parts for industrial machinery, pump equipment, controls and instrumentation cabinets.
Content matrix
Filter by the sector the part was built for. Each case study covers the part, the constraint, the route and the inspection — not the sales pitch.
Industrial equipment & controls
This housing is the machined body that holds bearings, seals and a shaft in correct alignment within a fluid-handling assembly. It must hold those bores concentric…
Send your drawing for review
Industrial equipment & controls
This plate is a sliding wear component in machinery. Geometrically it is simple: a flat plate carrying milled slots and counterbored fixing holes. What makes or…
Send your drawing for review
Industrial equipment & controls
A two-part sealed enclosure: a hollow extruded body with an internal cavity and a removable lid that clamps onto a CNC-machined O-ring gland — built for…
Send your drawing for review
Industrial equipment & controls
A pneumatic manifold machined from 6061-T6 aluminum: valves and fittings on the outside, a network of cross-drilled passages on the inside, sealed, leak tested and finished…
Send your drawing for reviewSend your drawing, alloy, finish, tolerances and estimated quantity. We reply within one business day.
